Command Line Interface
4-250
4
Command Usage
• The command affects both static and dynamic unicast routing.
• If IP routing is enabled, all IP packets are routed using either static routing or
dynamic routing via RIP or OSPF, and other packets for all non-IP protocols
(e.g., NetBuei, NetWare or AppleTalk) are switched based on MAC
addresses. If IP routing is disabled, all packets are switched, with filtering and
forwarding decisions based strictly on MAC addresses.
Example
ip route
This command configures static routes. Use the no form to remove static routes.
Syntax
ip route {destination-ip netmask | default} {gateway} [metric metric]
no ip route {destination-ip netmask | default | *}
• destination-ip – IP address of the destination network, subnetwork, or host.
• netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
• default – Sets this entry as the default route.
• gateway – IP address of the gateway used for this route.
• metric – Selected RIP cost for this interface. (Range: 1-5, default: 1)
• * – Removes all static routing table entries.
Default Setting
No static routes are configured.
Command Mode
Global Configuration
Command Usage
• You can configure up to 256 static routes.
• Static routes take precedence over dynamically learned routes.
• Static routes are included in RIP updates periodically sent by the router.
Example
This example forwards all traffic for subnet 192.168.1.0 to the router 192.168.5.254,
using the default metric of 1.
Console(config)#ip routing
Console(config)#
Console(config)#ip route 192.168.1.0 255.255.255.0 192.168.5.254
Console(config)#
To Next Page
Loading...
Need help?
General
