Edge-Core ES4625 - Mac Access-Group; Show Mac Access-Group

Access Control List Commands
4-105
4
mac access-group
This command binds a port to a MAC ACL. Use the no form to remove the port.
Syntax
mac access-group acl_name {in | out}
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• in – Indicates that this list applies to ingress packets.
• out – Indicates that this list applies to egress packets.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
• You must configure a mask for an ACL rule before you can bind it to a port.
Example
Related Commands
show mac access-list (4-101)
show mac access-group
This command shows the ports assigned to MAC ACLs.
Command Mode
Privileged Exec
Example
Related Commands
mac access-group (4-105)
Console(config)#interface ethernet 1/2
Console(config-if)#mac access-group jerry in
Console(config-if)#
Console#show mac access-group
Interface ethernet 1/5
MAC access-list M5 out
Console#