System Management Commands
4-57
4
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows how to set the system clock to 15:12:34, February 1st, 2002.
show calendar
This command displays the system clock.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Example
System Status Commands
show startup-config
This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Default Setting
None
Command Mode
Privileged Exec
Console#calendar set 15:12:34 1 February 2002
Console#
Console#show calendar
15:12:34 February 1 2002
Console#
Table 4-23 System Status Commands
Command Function Mode Page
show startup-config Displays the contents of the configuration file (stored in flash
memory) that is used to start up the system
PE 4-57
show running-config Displays the configuration data currently in use PE 4-59
show system Displays system information NE, PE 4-61
show users Shows all active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
NE, PE 4-62
show version Displays version information for the system NE, PE 4-62
To Next Page
Loading...
Need help?
General
