DHCP Commands
4-133
4
Example
Related Commands
client-identifier (4-133)
hardware-address (4-134)
client-identifier
This command specifies the client identifier of a DHCP client. Use the no form to
remove the client identifier.
Syntax
client-identifier {text text | hex hex}
no client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
DHCP Pool Configuration
Command Usage
• This command identifies a DHCP client to bind to an address specified in the
host command. If both a client identifier and hardware address are configured
for a host address, the client identifier takes precedence over the hardware
address in the search procedure.
• BOOTP clients cannot transmit a client identifier. To bind an address to a
BOOTP client, you must associate a hardware address with the host entry.
Example
Related Commands
host (4-132)
Console(config-dhcp)#host 10.1.0.21 255.255.255.0
Console(config-dhcp)#
Console(config-dhcp)#client-identifier text steve
Console(config-dhcp)#
To Next Page
Loading...
Need help?
General
