Edge-Core ES4625 - System Management Commands; Device Designation Commands; Prompt; Table 4-7 System Management Commands

System Management Commands
4-25
4
System Management Commands
These commands are used to control system logs, passwords, user names, browser
configuration options, and display or configure a variety of other system information.
Device Designation Commands
prompt
This command customizes the CLI prompt. Use the no form to restore the default
prompt.
Syntax
prompt string
no prompt
string - Any alphanumeric string to use for the CLI prompt.
(Maximum length: 255 characters)
Default Setting
Console
Table 4-7 System Management Commands
Command Group Function Page
Device Designation Configures information that uniquely identifies this switch 4-25
User Access Configures the basic user names and passwords for management access 4-27
IP Filter Configures IP addresses that are allowed management access 4-29
Web Server Enables management access via a web browser 4-31
Telnet Server Enables management access via Telnet 4-34
Secure Shell Provides secure replacement for Telnet 4-34
Event Logging Controls logging of error messages 4-43
SMTP Alerts Configures SMTP email alerts 4-49
Time (System Clock) Sets the system clock automatically via NTP/SNTP server or manually 4-53
System Status Displays system configuration, active managers, and version information 4-57
Frame Size Enables support for jumbo frames 4-63
Table 4-8 Device Designation Commands
Command Function Mode Page
prompt Customizes the prompt used in PE and NE mode GC 4-25
hostname Specifies the host name for the switch GC 4-26
snmp-server contact Sets the system contact string GC 4-109
snmp-server location Sets the system location string GC 4-110
switch renumber Renumbers stack units PE 4-26