Command Line Interface
4-68
4
Command Usage
• If you enter the command dir without any parameters, the system displays all
files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Example
The following example shows how to display all file information:
whichboot
This command displays which files were booted when the system powered up.
Syntax
whichboot [unit]
unit - Stack unit. (Range: 1-8)
Default Setting
None
Command Mode
Privileged Exec
Table 4-26 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
Console#dir
file name file type startup size (byte)
------------------------------------- -------------- ------- -----------
Unit1:
D1014 Boot-Rom Image Y 825336
V1000-F Operation Code N 3504992
V31121 Operation Code Y 4951408
Factory_Default_Config.cfg Config File N 455
startup1.cfg Config File Y 7996
---------------------------------------------------------------------------
Total free space: 22675456
Console#
To Next Page
Loading...
