Command Line Interface
4-128
4
Command Mode
DHCP Pool Configuration
Usage Guidelines
The IP address of the router should be on the same subnet as the client. You
can specify up to two routers. Routers are listed in order of preference
(starting with address1 as the most preferred router).
Example
domain-name
This command specifies the domain name for a DHCP client. Use the no form to
remove the domain name.
Syntax
domain-name domain
no domain-name
domain - Specifies the domain name of the client.
(Range: 1-32 characters)
Default Setting
None
Command Mode
DHCP Pool Configuration
Example
dns-server
This command specifies the Domain Name System (DNS) IP servers available to a
DHCP client. Use the no form to remove the DNS server list.
Syntax
dns-server address1 [address2]
no dns-server
• address1 - Specifies the IP address of the primary DNS server.
• address2 - Specifies the IP address of the alternate DNS server.
Default Setting
None
Command Mode
DHCP Pool Configuration
Console(config-dhcp)#default-router 10.1.0.54 10.1.0.64
Console(config-dhcp)#
Console(config-dhcp)#domain-name sample.com
Console(config-dhcp)#
To Next Page
Loading...
Need help?
General
