Multicast Routing
3-267
3
Web – Click Routing Protocol, DVMRP, General Settings. Enable or disable
DVMRP. Set the global parameters that control neighbor timeout, the exchange of
routing information, or the prune lifetime, and click Apply.
Figure 3-150 DVMRP General Settings
CLI – This sets the global parameters for DVMRP and displays the current settings.
Configuring DVMRP Interface Settings
To fully enable DVMRP, you need to enable multicast routing globally for the router
(page 3-260), enable DVMRP globally for the router (page 3-264), and also enable
DVMRP for each interface that will participate in multicast routing.
Command Attributes
DVMRP Interface Information
• Interface – VLAN interface on this router that has enabled DVMRP.
• Address – IP address of this VLAN interface.
• Metric – The metric for this interface used to calculate distance vectors.
• Status – Shows that DVMRP is enabled on this interface.
Console(config)#router dvmrp 4-299
Console(config-router)#probe-interval 30 4-300
Console(config-router)#nbr-timeout 40 4-301
Console(config-router)#report-interval 90 4-301
Console(config-router)#flash-update-interval 10 4-302
Console(config-router)#prune-lifetime 5000 4-302
Console(config-router)#default-gateway 10.1.0.253 4-303
Console(config-router)#end
Console#show router dvmrp 4-305
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway :
Console#
To Next Page
Loading...
Need help?
General
