Edge-Core ES4625 - Page 142

Configuring the Switch
3-90
3
• Broadcast storm – Shows if broadcast storm control is enabled or disabled.
• Broadcast storm limit – Shows the broadcast storm threshold. (500 - 262143
packets per second)
• Flow control
8
– Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port security – Shows if port security is enabled or disabled.
• Max MAC count – Shows the maximum number of MAC address that can be
learned by a port. (0 - 1024 addresses)
• Port security action – Shows the response to take when a security violation is
detected. (shutdown, trap, trap-and-shutdown)
• Media type – Shows the forced/preferred port type to use for combination ports
21-24 (ES4625) or 45-48 (ES4649). (copper forced, SFP forced, SFP preferred auto)
Current status:
• Link status – Indicates if the link is up or down.
• Port operation status – Provides detailed information on port state.
(Displayed only when the link is up.).
• Operation speed-duplex – Shows the current speed and duplex mode.
• Flow control type
8
– Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
CLI – This example shows the connection status for Port 5.
8. There are interoperability problems between Flow Control and Head-of-Line (HOL) blocking
for the switch ASIC; Flow Control is therefore not supported for this switch.
Console#show interfaces status ethernet 1/5 4-150
Information of Eth 1/13
Basic information:
Port type: 1000T
Mac address: 00-30-F1-D4-73-A5
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full
Broadcast storm: Enabled
Broadcast storm limit: 500 packets/second
Flow control: Disabled
LACP: Disabled
Port security: Disabled
Max MAC count: 0
Port security action: None
Media type: None
Current status:
Link status: Down
Operation speed-duplex: 1000full
Flow control type: None
Console#