STP-iXA2205 Series Turbomolecular Pump
!"#$%&'% )0% *++,-%&./%
0
SERIAL COMMUNICATION PROTOCOL
5.2.5 Serial communication timeout setting
*F% </-% +4GA@?% <"% </-% 4A9,<% "9-8@<4"A% 9"8<% "F% </-% 123% 9,>9% 4+% 4A<-88,9<-:% F"8% @% =-8<@4A% 9-84":% :,84AG%
@==-?-8@<4"A%"8%A"8>@?%"9-8@<4"AI%</-%123%9,>9%:-<-=<+%@%F@4?,8-%@A:%+<"9+$%2/-%<4>-%+-<<4AG%"F%</-%
F@4?,8-%:-<-=<4"A%4+%,+-8%:-F4A@J?-$%Z/-A%+-<<4AG%</-%#@?,-%<"%'I%</-%F,A=<4"A%4+%:4+@J?-:$%2/4+%#@?,-%;4??%
J-%=">>"A%<"%@??%+-84@?%9"8<+I%@A:%</-%F@=<"8K%+-<<4AG%4+%&%>4A,<-$%
2/-%+-<<4AG%#@?,-%=@A%J-%=/@AG-:%#4@%+-84@?%=">>,A4=@<4"AI%</-%123.M4AN%O"9<4"A@?%@==-++"8KP$O+--%
0$E$&`P%
Q-+4GA% </-% ,+-8% @99?4=@<4"A% +"% </@<% </-% 3T% =@A% =">>,A4=@<-% ;4</% </-% 123% 9,>9% @<% F4[-:% 8-G,?@8%
4A<-8#@?+%;4</4A%</-%+-<<4AG%<4>-I%-[=-9<%;/-A%</-%F,A=<4"A%4+%:4+@J?-:%O</-%#@?,-%4+%'P$%
Default Setting Range Remark
1-84@?%
=">>,A4=@<4"A%
<4>-%",<%+-<<4AG%
&%>4A,<-% '%<"%0''%>4A,<-+%
O&%>4A,<-%+<-9P%
2/-%F,A=<4"A%4+%:4+@J?-:%;/-A%</-%
#@?,-%4+%+-<%<"%'$%
2@J?-%7)%.%1-84@?%=">>,A4=@<4"A%<4>-%",<%+-<<4AG%
Note: When the communication time out is disabled, the STP pump may not stop when the serial
communication does not function normally due to a breakage of the communication cable. In
this case, interrupt the power supply for 2 seconds or more to stop the STP pump by power
failure detection. Supply the power to the STP pump immediately after power failure
detection.
To Next Page
Loading...
