98Installation and Service Guide: Color Controller E-85
Installing System Software
• Restore from backup or recovery partition: You can restore the system by selecting the backups that you created
before. If there is no backup available in the system or in any attached devices, you can only perform the restore from
the recovery partition. “Restoring the system configuration” on page 89.
• Back up hard disk drive(s): Use this option when you create the system backups. You can specify the location of the
backup, file name, and other attributes of the backups.“Backup with Fiery System Installer” on page 92.
• Platform Utilities: You can perform the backup management tasks from this option such as erasing hard disks or using
Windows Task Manager to explore the system.“Platform Utilities” on page 95.
Note: You can use the Fiery QuickTouch to operate Fiery System Installer. You can also use a monitor, mouse, and
keyboard attached if available.
The System Software installation takes approximately 2 hours to complete.
If you do not, installation will fail.
1 Insert System Software DVD 1 into the DVD drive.
2 Reboot the E-85.
Wait while the system boots from the DVD.
3 When the language selection screen displays, select a language.
4 When “What do you want to do?” screen displays four choices, select New Installation.
You can choose to skip installation or install each of the following. If you choose to install, you will need the DVDs to
complete these installations. If you choose to skip, you can install the optional software later.
5 After you select New Installation, a warning message appears as follows:
“This installation will erase all data on the hard disk drive(s). Continue?
• Click Continue to the New Installation
• Click the back arrow to exit and return to the previous menu.
6 After copying the System Software DVD 1 contents to the hard drive (approximately five to seven minutes), when
prompted, eject the DVD and insert the System Software DVD 2.
7 After copying the System Software DVD 2 contents to the hard drive (approximately five to seven ten minutes), when
prompted, eject the DVD and insert the System Software DVD 3.
8 After copying the System Software DVD 3 contents to the hard drive (approximately eight minutes), when prompted,
eject the DVD and insert the User Software DVD 4.
When the contents of the User Software DVD 4 are copied to the hard disk (approximately eight minutes after), eject
the User Software DVD 4. The E-85 reboots to begin the software installation.
To Next Page
Loading...
Need help?
General
