Endress+Hauser Proline Promass 83 - Group SENSOR DATA; Function Group CONFIGURATION

Device Functions Proline Promass 83 MODBUS RS485 9 Block BASIC FUNCTION
Endress+Hauser 119
9.4 Group SENSOR DATA
9.4.1 Function group CONFIGURATION
BASIC FUNCTION G → MODBUS RS485 GDA
→
PROCESS PARAMETER GIA
→
SYSTEM PARAMETER GLA
→
SENSOR DATA GNA → CONFIGURATION 680
Function description
BASIC FUNCTION → SENSOR DATA → CONFIGURATION
All sensor data (calibration factor, zero point and nominal diameter) are set at the factory and saved on the S-DAT sensor
memory chip.
" Caution!
Under normal circumstances you should not change the following parameter settings, because changes affect numerous
functions of the entire measuring facility in general and the accuracy of the measuring system in particular. For this
reason, the functions described below cannot be changed even when you enter your personal code.
Contact the Endress+Hauser service organization if you have any questions about these functions.
! Note!
The individual values of the functions are also provided on the sensor nameplate.
K-FACTOR
MODBUS register:
Data type:
Access:
6800
7513
Float
read
This function shows the current calibration factor for the sensor.
Factory setting: Depends on nominal diameter and calibration
ZERO POINT
MODBUS register:
Data type:
Access:
6803
7527
Float
read/write
This function shows the current zero point correction value for the sensor.
Display: max. 5-digit number: -99999 to +99999
Factory setting: Depends on calibration
NOMINAL
DIAMETER
MODBUS register:
mm
inch
Data type:
Access:
6804
7525
7526
Integer
read
Display: Nominal diameter for the sensor
0 = DN 1 or 1/24"
1 = DN 2 or 1/12"
2 = DN 3 or 1/8"
3 = DN 3.5 or 9/64"
4 = DN 4 or 5/32"
5 = DN 6 or 1/4"
6 = DN 8 or 5/16"
7 = DN 10 or 3/8"
8 = DN 15 or 1/2"
9 = DN 15 FB or 1/2" FB (FB = full bore)
10 = DN 20 or 3/4"
11 = DN 25 or 1"
12 = DN 25 FB or 1" FB
13 = DN 32 or 1 1/4"
14 = DN 40 or 1 1/2"
15 = DN 40 FB or 1 1/2" FB
16 = DN 50 or 2"
17 = DN 50 FB or 2" FB
18 = DN 65 or 2 1/2"
19 = DN 80 or 3"
20 = DN 100 or 4"
21 = DN 125 or 5"
22 = DN 150 or 6"
23 = DN 200 or 8"
24 = DN 250 or 10"