Endress+Hauser Proline Promass 83 - Function Group; Additional Coefficient

9 Block BASIC FUNCTION Device Functions Proline Promass 83 MODBUS RS485
122 Endress+Hauser
9.4.4 Function group ADDITIONAL COEFFICIENT
BASIC FUNCTION G → MODBUS RS485 GDA
→
PROCESS PARAMETER GIA
→
SYSTEM PARAMETER GLA
→
SENSOR DATA GNA → CONFIGURATION 680
→
FLOW COEFFICIENT 684
→
DENSITY COEFFICIENT 685
→
ADDITIONAL
COEFFICIENT
686
Function description
BASIC FUNCTION → SENSOR DATA → ADDITIONAL COEFFICIENT
All sensor data are set at the factory. All the sensor's parameter settings are saved on the S-DAT memory chip.
" Caution!
These functions are used for displaying device parameters only and consequently cannot be accessed.
Contact the Endress+Hauser service organization if you have any questions about these functions.
MINIMAL
TEMPERATURE
MEASURED
MODBUS register:
Data type:
Access:
6860
7529
Float
read
The lowest fluid temperature measured appears on the display.
MAXIMAL
TEMPERATURE
MEASURED
MODBUS register:
Data type:
Access:
6861
7531
Float
read
The highest fluid temperature measured appears on the display.
MINIMAL
TEMPERATURE
CARRIER TUBE
MODBUS register:
Data type:
Access:
6862
7533
Float
read
! Note!
This function is not available for the Promass E measuring device.
The lowest carrier tube temperature measured appears on the display.
MAXIMAL
TEMPERATURE
CARRIER TUBE
MODBUS register:
Data type:
Access:
6863
7535
Float
read
! Note!
This function is not available for the Promass E measuring device.
The highest carrier tube temperature measured appears on the display.