Device Functions Proline Promass 83 MODBUS RS485 4 Block QUICK SETUP
Endress+Hauser 27
4.3 “Pulsating flow” Quick Setup menu
!
Note!
The Quick Setup “Pulsating flow” is only available if the device has a current output or a
pulse/frequency output. Certain types of pump such as reciprocating, peristaltic and cam-type
pumps, for example, create a flow characterized by severe periodic fluctuations. Negative flows can
occur with pumps of these types on account of the closing volume of the valves or valve leaks.
!
Note!
Before carrying out the Quick Setup “Pulsating Flow” the Quick Setup “Commissioning”
(see Page 22) has to be executed.
A0002615-en
m Only totalizers not yet configured in the current Setup are offered for selection in each cycle.
n The “YES” option remains visible until all the totalizers have been parameterized. “NO” is the only option displayed
when no further totalizers are available.
o The prompt only appears if a current output and/or a pulse/frequency output is available. Only the outputs not yet
configured in the current Quick Setup are offered for selection in each cycle.
p The “YES” option remains visible until all the outputs have been parameterized. “NO” is the only option displayed
when no further outputs are available.
+
+
E
+
E
3002 3002
3002
4200
4225
8005
6400
6402
6403
6404
4206
4208
4004
4005
B
2002
1003
Esc
E
+
-
XXX.XXX.XX
Yes
Yes
No
No
n
Configure another totalizer ?
o
Current output n Freq.-/Puse output n
Selection of output type
Quit
m
Totalizer 2Totalizer 1
Totalizer 3
Selection totalizer
Quit
Totalizer
mode (DAA)
Totalizer
mode (DAB)
Totalizer
mode (DAC)
Frequency Pulse
Operation mode
Measuring mode
Alarm delay
Assign
LF-Cut off
On-value
LF-Cut off
Off-value
LF-Cut off
Pressure
shock suppression
Quit
Quick Setup
Measuring mode
Time constant
Measuring mode
Time constant
Quick Setup
HOME-POSITION
Display
damping
QS
Plusating Flow
p
Configure another output ?
To Next Page
Loading...
