Endress+Hauser Proline Promass 83 - Page 28

4 Block QUICK SETUP Device Functions Proline Promass 83 MODBUS RS485
28 Endress+Hauser
!
Note!
• The display returns to the cell SETUP PULSATING FLOW (1003) if you press the X key
combination during parameter interrogation.
• You can call up the Setup menu either directly from the “COMMISSIONING” Quick Setup
menu or manually by means of the function QUICK SETUP PULSATING FLOW (1003).
Settings for the Pulsating Flow Setup menu:
Fct. code Function name Suggested settings Description
Call up through the function matrix:
B QUICK SETUP QUICK SETUP PULSATING FLOW see P. 20
1003 QUICK SETUP PULSATING YES see P. 20
Basic configuration:
2002 DISPLAY DAMPING 1 second see P. 34
3002 TOTALIZER MODE (DAA) BALANCE see P. 55
3002 TOTALIZER MODE (DAB) BALANCE see P. 55
3002 TOTALIZER MODE (DAC) BALANCE see P. 55
Select the signal type: CURRENT OUTPUT 1
4004 MEASURING MODE PULSATING FLOW see P. 62
4005 TIME CONSTANT 1 second see P. 65
Select the signal type: FREQ./PULSE OUTPUT 1 / operating mode: FREQUENCY
4206 MEASURING MODE PULSATING FLOW see P. 66
4208 TIME CONSTANT 0 seconds see P. 78
Select the signal type: FREQ./PULSE OUTPUT 1 / operating mode: PULSE
4225 MEASURING MODE PULSATING FLOW see P. 80
Other settings:
8005 ALARM DELAY 0 seconds see P. 168
6400 ASSIGN LF CUT OFF MASS FLOW see P. 109
6402 ON-VALUE LOW FLOW CUT
OFF
Depends on diameter (DN [mm]):
– DN 1 = 0.02 [kg/h] resp. [l/h]
– DN 2 = 0.10 [kg/h] resp. [l/h]
– DN 4 = 0.45 [kg/h] resp. [l/h]
– DN 8 = 2.0 [kg/h] resp. [l/h]
– DN 15 = 6.5 [kg/h] resp. [l/h]
– DN 15* = 18 [kg/h] resp. [l/h]
– DN 25 = 18 [kg/h] resp. [l/h]
– DN 25* = 45 [kg/h] resp. [l/h]
– DN 40 = 45 [kg/h] resp. [l/h]
– DN 40* = 70 [kg/h] resp. [l/h]
– DN 50 = 70 [kg/h] resp. [l/h]
– DN 50* = 180 [kg/h] resp. [l/h]
– DN 80 = 180 [kg/h] resp. [l/h]
– DN 100 = 350 [kg/h] resp. [l/h]
– DN 150 = 650 [kg/h] resp. [l/h]
– DN 250 = 1800 [kg/h] resp. [l/h]
*DN 15, 25, 40, 50 “FB” = Full bore
versions of Promass I
see P. 109
6403 OFF-VALUE LOW FLOW CUT
OFF
50% see P. 109
6404 PRESSURE SHOCK
SUPPRESSION
0 s see P. 110