Endress+Hauser Proline Promass 83 - Group ADVANCED DIAGNOSTICS; Function Group CONFIGURATION

Device Functions Proline Promass 83 MODBUS RS485 10 Block SPECIAL FUNCTION
Endress+Hauser 149
10.3 Group ADVANCED DIAGNOSTICS
10.3.1 Function group CONFIGURATION
SPECIAL FUNCTION H → DENSITY FUNCTIONS HAA
→
BATCHING FUNCTION HCA
→
ADVANCED
DIAGNOSTICS
HEA
→
CONFIGURATION 740
Function description
SPECIAL FUNCTION → ADVANCED DIAGNOSTICS → CONFIGURATION
REFERENCE
CONDITION USER
MODBUS register:
Data type:
Access:
7401
6707
Integer
read/write
Use this function to start determining the user reference status. The following
values are determined:
•MASS FLOW
•DENSITY
• REFERENCE DENSITY
• TEMPERATURE
•TUBE DAMPING
• ELECTRODYNAMIC SENSORS
• OPERATING FREQUENCY FLUCTUATION
• TUBE DAMPING FLUCTUATION
Options:
0 = CANCEL
1 = START
Factory setting: CANCEL
SELECT
REFERENCE
CONDITION
MODBUS register:
Data type:
Access:
7402
6708
Integer
read/write
Use this function to select the reference status which should be used to compare
the advanced diagnosis parameters (see function ACQUISITION MODE (7410)
on Page 150).
Options:
0 = FACTORY
1 = USER
Factory setting: FACTORY
WARNING MODE
MODBUS register:
Data type:
Access:
7403
6709
Integer
read/write
Use this function to determine whether a warning should be generated when
there is a deviation between the reference status (FACTORY or USER, see
function SELECT REFERENCE CONDITION, 7402) and the current measuring
values. The values of the following functions are compared to the reference status:
• MASS FLOW (7421)
• DENSITY (7431)
• REFERENCE DENSITY (7441)
• TEMPERATURE (7451)
•TUBE DAMPING (7461)
• ELECTRODYNAMIC SENSORS (7471)
• OPERATING FREQUENCY FLUCTUATION (7481)
• TUBE DAMPING FLUCTUATION (7491)
Options:
0 = OFF
1 = ON
Factory setting: OFF