Endress+Hauser Proline Promass 83 - Function Group DENSITY COEFFICIENT

Device Functions Proline Promass 83 MODBUS RS485 9 Block BASIC FUNCTION
Endress+Hauser 121
9.4.3 Function group DENSITY COEFFICIENT
BASIC FUNCTION G → MODBUS RS485 GDA
→
PROCESS PARAMETER GIA
→
SYSTEM PARAMETER GLA
→
SENSOR DATA GNA → CONFIGURATION 680
→
FLOW COEFFICIENT 684
→
DENSITY COEFFICIENT 685
Function description
BASIC FUNCTION → SENSOR DATA → DENSITY COEFFICIENT
All density coefficients are set at the factory. All the sensor's parameter settings are saved on the S-DAT memory chip.
Contact the Endress+Hauser service organization if you have any questions about these functions.
DENSITY
COEFF. C 0
MODBUS register:
Data type:
Access:
6850
7501
Float
read
This function shows the actual density coefficient C 0.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY
COEFF. C 1
MODBUS register:
Data type:
Access:
6851
7503
Float
read
This function shows the actual density coefficient C 1.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY
COEFF. C 2
MODBUS register:
Data type:
Access:
6852
7505
Float
read
This function shows the actual density coefficient C 2.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY
COEFF. C 3
MODBUS register:
Data type:
Access:
6853
7507
Float
read
This function shows the actual density coefficient C 3.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY
COEFF. C 4
MODBUS register:
Data type:
Access:
6854
7509
Float
read
This function shows the actual density coefficient C 4.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY
COEFF. C 5
MODBUS register:
Data type:
Access:
6855
7511
Float
read
This function shows the actual density coefficient C 5.
" Caution!
A density adjustment can alter the calibration value of this coefficient.