Device Functions Proline Promass 83 MODBUS RS485 4 Block QUICK SETUP
Endress+Hauser 23
!
Note!
• The display returns to the cell SETUP COMMISSION (1002) if you press the X key combination
during parameter interrogation. The stored parameters remain valid.
• The “Commissioning” Quick Setup must be carried out before one of the Quick Setups
explained below is run.
m The DELIVERY SETTINGS option sets every selected unit to the factory setting.
The ACTUAL SETTING accepts the units you configured beforehand.
n Only units not yet configured in the current Setup are offered for selection in each cycle. The unit for mass,
volume and corrected volume is derived from the corresponding flow unit.
o The “YES” option remains visible until all the units have been configured.
“NO” is the only option displayed when no further units are available.
p The prompt only appears if a current output and/or a pulse/frequency output is available. Only the outputs not yet
configured in the current Setup are offered for selection in each cycle.
q The “YES” option remains visible until all the outputs have been parameterized. “NO” is the only option displayed
when no further outputs are available.
r The “automatic parameterization of the display” option contains the following basic settings/factory settings:
YES: Main line = Mass flow; Additional line = Totalizer 1; Information line = Operating/system conditions
NO: The existing (selected) settings remain.
s The BATCHING QUICK SETUP is only available when the optional software package BATCHING is installed.
t The PULSATING FLOW QUICK SETUP is only available if the measuring device
has a current output or pulse/frequency output.
To Next Page
Loading...
