Epson RC180 - Mount Option Unit 1, 2

Maintenance 6. Maintenance Parts Replacement Procedures
166 RC180 Rev.17
6.7.6 Mount Option Units 1 & 2
(1)
Secure Option Units 1 and 2 with
two screws each on front and backside.
(2)
Connect the flat cable connector to the backside
of Option Unit 1.
Connecting Connector
Back of Controller
Main Chassis
Option Unit 1
(3)
Secure the backside covers of Option Unit 1 with two screws for each.
(4)
Plug in
the power connector. Turn ON the Controller and make sure that the
Controller starts properly without any vibration or abnormal noise.