Setup & Operation 7. LAN (Ethernet Communication) Port
46 RC180 Rev.17
7.2 IP Address
Set the proper IP address or subnet mask depending on the Controller and development PC
configuration to use the LAN port.
Do not input a random value for the IP address of the network configured TCP/IP. This
is the only address that specifies the computer using an Internet connection.
The IP address is assigned from the company or organization that has control of IP
address.
Use an address from the following Internet private environment such as P2P or line.
Make sure that the address is not redundantly assigned inside the closed network.
Private Address List
10.0.0.1 to 10.255.255.254
172.16.0.1 to 172.31.255.254
192.168.0.1 to 192.168.255.254
The following is the configuration of the controller at delivery.
IP Address : 192.168.0.1
IP Mask : 255.255.255.0
IP Gateway : 0.0.0.0
7.3 Changing Controller IP Address
In this section, the procedure to change the Controller IP address when connecting
Controller development PC connection port and the development PC by the USB cable is
indicated.
(1) For connection between the development PC and the Controller, refer to Setup &
Operation 5.3 Connection of Development PC and Controller.
(2) Select the EPSON RC+ 5.0 menu-[Setup]-[Controller] to display the [Setup
Controller] dialog.
To Next Page
Loading...
Need help?
General
