Epson RC180 User Manual

Setup & Operation 7. LAN (Ethernet Communication) Port
RC180 Rev.17 47
(3) Enter the proper IP address and subnet mask and click the <Apply> button.
(4) Click the <Close> button. The Controller reboots automatically.
IP address configuration is completed and the Controller reboot dialog disappears.
(5) Connect the Ethernet cable to the Controller LAN port.
When the Controller and the development PC are connected via the Ethernet, the
Controller IP address can also be changed. However, Controller and the development PC
do not connect automatically after rebooting the Controller at Ethernet connection.

NOTE

Epson RC180 Specifications

General

Brand	Epson
Model	RC180
Category	Controller
Language	English