Epson RC180 - Setup from Control Device

Setup & Operation 4. Operation Mode (TEACH/AUTO)
36 RC180 Rev.17
4.4.3 Setup from Control Device
Set the control device from EPSON RC+ 5.0.
(1) Select EPSON RC+ 5.0 menu-[Setup]-[Controller] to display the [Setup Controller]
dialog.
(2)
(5)
(3)
(4)
(2) Select [Configuration].
(3) Select [Setup Controller]-[Control Device] to select the control device from the
following three types.
PC
Remote (I/O)
OP (Option: Operator Panel)
(4) Click the <Apply> button.
(5) Click the <Close> button.