Epson RC180 - Page 193

Maintenance 8. Trouble Shooting
RC180 Rev.17 181
Simulator
No. Message Remedy Note 1 Note 2
1861
Initialization failure. Failed to
initialize SimulatorMNG.
1. Reboot the EPSON RC+ 5.0.
2. Reboot the PC.
3. Reinstall the EPSON RC+ 5.0.
1862
Initialization failure. Failed to
initialize WBProxy.
1. Reboot the EPSON RC+ 5.0.
2. Reboot the PC.
3. Reinstall the EPSON RC+ 5.0.
1863
The parameter is invalid.
1864
Initialization failure. Virtual controller
does not exist.
Installation of EPSON RC+ 5.0 failed.
Reinstall EPSON RC+ 5.0.
1865
Initialization failure. Failed to start
virtual controller.
1. Retry after a while.
2. Reboot the PC.
1867
Cannot execute because it is not dry
run mode.
Dry run mode is invalid.
Enable the dry run.
1868
Initialization failure. Directory cannot
be found.
Installation of the EPSON RC+ 5.0
failed. Reinstall the software.
1870
Pallet failure. Number of point is
beyond the maximum value.
1871
Connection failure. Virtual controller
version is old.
1872
Connection failure. Files for simulator
that used real controller cannot be
found.
1873
Connection failure. Files for simulator
that used virtual controller cannot be
found.
Register the virtual controller again in
the connection setting.
1874 Virtual Controller cannot be added.
Installation of EPSON RC+ 5.0 failed.
Reinstall the software.
1875
Simulator
Object failure. Cannot
register data of the simulator object.
1876
Simulator Object failure. Cannot
register data of the simulator object.
1877
Simulator Object failure. Cannot
remove data of the simulator object.
1878
Simulator Object failure. Cannot
update data of the simulator object.
1879 Other virtual controllers are starting.
Start another EPSON RC+5.0 and check
if it connects with the virtual controller.
1880 Cannot execute during controller reset.