Epson RC180 - Page 214

Maintenance 8. Trouble Shooting
RC180 Rev.17
202
No. Message Remedy Note 1 Note 2
3121 Corresponding Send cannot be found.
The number of Send statements that
correspond to Select statements is not
enough. Add the Send statements.
3123
On/Off statements are
beyond the
maximum count.
An upper limit (max. 16) is set on the
number of On/Off statements in Curve
statement
. Check the upper limit and
correct the program.
3124
Point number is beyond the maximum
count.
An upper limit (“200” for open curves,
“50” for closed curves) is set on the
available number of points
in Curve
statement
. Check the upper limit and
correct the program.
3125 Corresponding If cannot be found.
The number of EndIf statements that
correspond to If statements is
too many.
Delete the unnecessary EndIf.
3126 Corresponding Do cannot be found.
The number of Loop statements that
correspond to Do statements is too many.
Delete the unnecessary Loop.
3127 Corresponding Select cannot be found.
The number of Send statements that
correspond to Select statements is too
many. Delete the unnecessary Send.
3128 Corresponding For cannot be found.
The number of Next statements that
correspond to For statements
is too
many. Delete the unnecessary Next.
3129
'_' cannot be used as the first character
of an identifier.
Change the first character of the
identifier to an alphabetic character.
3130 Cannot specify ROT parameter.
ROT parameter cannot be specified in
BGo, Go, TGo, Jump, and Jump3
statements. Correct the program.
3131 Cannot specify ECP parameter.
ECP parameter cannot be specified in
BGo, Go, TGo, Jump, Jump3, and Arc
statements. Correct the program.
3132 Cannot specify Arch parameter.
Arch parameter cannot be specified in
BGo, Go, TGo, Arc, Arc3, BMove,
Move, and TMove statements. Correct
the program
3133 Cannot specify LimZ parameter.
LimZ parameter cannot be specified in
BGo, Go, TGo, Jump3, Arc, Arc3,
BMove
, Move, and TMove statements.
Correct the program.
3134 Cannot specify Sense parameter.
Sense parameter cannot be specified in
BGo, Go, TGo, Arc, Arc3, BMove,
Move, and TMove statements. Correct
the program.
3135 Invalid parameter is specified.
Invalid parameter is specified in Xqt, and
Call statements. Correct the program.
3136
Cannot use #include.
3137
Cannot specify the array variable
subscript.
The array variable subscript cannot be
specified. Correct the program.
3138
ByRef
was not specified on Function
declaration.
Specify ByRef in the parameter list of
function declaration that is called by Call
statement.
3139
Cannot execute the Xqt statement for a
function that needs a ByRef
parameter.
The Xqt statement cannot be executed
for a function needing a ByRef
parameter. Delete the ByRef parameter.