Epson RC180

Maintenance 8. Trouble Shooting
RC180 Rev.17 233
No.
Message
Remedy
Note 1
Note 2
7030
Specified point label is beyond the
maximum length. Specify a valid point
label.
Change the point label.
7031
Description for the specified point is
beyond the maximum length. Specify
a valid description.
Change the comment.
7032
Point file is corrupted. Check sum
error.
Create the point file again.
7033
Specified point file cannot be found.
Specify a valid point file name.
Check the name of the specified point
file.
7034 Cannot save the point file.
Failed to save the point file (create a
temporary file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7035 Cannot save the point file.
Failed to save the point file (file open).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7036 Cannot save the point file.
Failed to save the point file (renew the
file header).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7037 Cannot save the point file.
Failed to save the point file (create the
file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7038 Cannot save the point file.
Failed to save the point file (copy the
file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7039 Cannot save the point file.
Failed to save the point file (change the
file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7040
The point label is not correct. Specify
a valid point point label.
The initial character of the point label
name is improper. Correct the label
name.
7041
The point label is not correct. Specify
a valid point point label.
Inadequate character is used.
Correct the label name.