Epson SC-F2000 - Page 42

SC-F2000 Revision C
TROUBLE SHOOTING Remedies for Service Call Error 42
Confidential
1F80
IES error (Ink End
Sensor error)
The 42V fuse on the MAIN BOARD has blown. Check the connection to the ink holders.
1. Replace the MAIN BOARD. (Page 95)
2. Replace the PRINT HEAD (Page 127), MAIN
BOARD. (Page 95), LEFT INK HOLDER ASSY
(Page 156) and RIGHT INK HOLDER ASSY
(Page 161) together at the same time.
3. Consult the service support division of your sales
company.
1FB8
IES error (Ink End
Sensor error)
ASIC communication error (CRCM Board)
---
1. Replace the LEFT INK HOLDER ASSY (Page
156) and RIGHT INK HOLDER ASSY (Page
161).
2. Replace the MAIN BOARD. (Page 95)
1FB9 CSIC error
CSIC control error NVRAM CS rank Replace the MAIN BOARD. (Page 95)
1FBE CSIC error
CSIC control error
1. Replace the Ink Cartridges.
2. Clean the terminals.
3. Check the cable connection.
1. Replace the LEFT INK HOLDER ASSY (Page
156) and RIGHT INK HOLDER ASSY (Page
161).
2. Replace the MAIN BOARD. (Page 95)
1FBF CSIC error
CSIC control error
1. Replace the Ink Cartridges.
2. Clean the terminals.
3. Check the cable connection.
1. Replace the LEFT INK HOLDER ASSY (Page
156) and RIGHT INK HOLDER ASSY (Page
161).
2. Replace the MAIN BOARD. (Page 95)
1FC0 CSIC error
CSIC control error
1. Replace the Ink Cartridges.
2. Clean the terminals.
3. Check the cable connection.
1. Replace the LEFT INK HOLDER ASSY (Page
156) and RIGHT INK HOLDER ASSY (Page
161).
2. Replace the MAIN BOARD. (Page 95)
1FC1 CSIC error
CSIC control error
1. Replace the Ink Cartridges.
2. Clean the terminals.
3. Check the cable connection.
1. Replace the LEFT INK HOLDER ASSY (Page
156) and RIGHT INK HOLDER ASSY (Page
161).
2. Replace the MAIN BOARD. (Page 95)
1FC2 CSIC error
CSIC control error
1. Replace the Ink Cartridges.
2. Clean the terminals.
3. Check the cable connection.
1. Replace the LEFT INK HOLDER ASSY (Page
156) and RIGHT INK HOLDER ASSY (Page
16
1).
2. Replace the MAIN BOARD. (Page 95)
2000 NVRAM error
NVRAM erase or write error has occurred.
---
Replace the MAIN BOARD. (Page 95)
2002 SDRAM error
Writing to the SDRAM was attempted, but nothing
could be written to it.
--- Replace the MAIN BOARD. (Page 95)
2003
FLASH BOOT
checksum error
 Installing the firmware has failed.
 The Flash ROM is out of order.
---
1. Re-install the firmware. (Page 219)
2. Replace the MAIN BOARD. (Page 95)
Code Error Name Cause Check Item Remedy