Epson SC-F2000 - Page 43

SC-F2000 Revision C
TROUBLE SHOOTING Remedies for Service Call Error 43
Confidential
2008
Wrong flash device
error
The circuit board is broken. Does the error persist after restarting the printer?
Replace the MAIN BOARD. (Page 95)
200A F/W load error
Reading/decompressing the firmware has failed.
---
1. Re-install the firmware. (Page 219)
2. Replace the MAIN BOARD. (Page 95)
200D
System interrupt
watchdog time-out error
A system failure such as CPU failure, or defective
cash has occurred.
---
Replace the MAIN BOARD. (Page 95)
200F
42 V circuit overcurrent
error
Overcurrent to the 42 V circuit was detected. Does the error persist after restarting the printer?
1. Replace the MAIN BOARD. (Page 95)
2. Replace the POWER SUPPLY BOARD. (Page
99)
3000 AC shut-off
The AC power has been shut off due to a power
failure, unplugged power cable, POWER SUPPLY
BOARD failure, or MAIN BOARD failure or the like.
Is the Power cable properly connected?
1. Replace the POWER SUPPLY BOARD. (Page
99)
2. Replace the MAIN BOARD. (Page 95)
1459
CWIP (CLOTH
WIPER) oscillation
error
 Motor becomes out of control.
 Motor is damaged.
 Circuit Board (motor driver) failure
Replace the WIPER UNIT. (Page 70)
1. Replace the WIPER UNIT. (Page 70)
2. Replace the CLOTH WIPER CARRIAGE
ASSY. (Page 146)
145A
CWIP (CLOTH
WIPER) overload error
 WIPER UNIT failure
 CLOTH WIPER CARRIAGE ASSY failure
 Motor is damaged.
 Circuit Board (motor driver) failure
 Motor cable is damaged.
 Encoder cable is damaged.
1. Replace the WIPER UNIT. (Page 70)
2. Is there any abnormality on the gears of the cloth
wiper carriage mechanism.
1. Replace the relay cable.
2. Replace the WIPER UNIT. (Page 70)
145B
CWIP (CLOTH
WIPER) over speed
error
 Encoder is damaged.
 Encoder cable is damaged.
Replace the WIPER UNIT. (Page 70)
1. Replace the relay cable.
2. Replace the WIPER UNIT. (Page 70)
145C
CWIP (CLOTH
WIPER) reversing error
 Encoder is damaged.
 Encoder cable is damaged.
Replace the WIPER UNIT. (Page 70)
1. Replace the relay cable.
2. Replace the WIPER UNIT. (Page 70)
145D
CWIP (CLOTH
WIPER) driving time-
out error
The circuit board is broken.
--- Replace the MAIN BOARD. (Page 95)
145E
CWIP (CLOTH
WIPER) velocity
deviation error
 Motor is damaged.
 Encoder is damaged.
 Encoder cable is damaged.
Replace the WIPER UNIT. (Page 70)
1. Replace the motor cable.
2. Replace the WIPER UNIT. (Page 70)
145F
CWIP (CLOTH
WIPER) lock error
 Motor is damaged.
 Encoder is damaged.
 Encoder cable is damaged.
Replace the WIPER UNIT. (Page 70)
1. Replace the motor cable.
2. Replace the WIPER UNIT. (Page 70)
Code Error Name Cause Check Item Remedy