Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 74
Confidential
• Operation
•–
The LD Roller is not set to the ASF home
position and paper is always loaded from
the ASF Unit during the paper loading
sequence.
ASF Unit
1. Check if the tip of the Change Lever is not damaged. 1. Replace the ASF Unit with a new one.
Table 3-11. Check point for Head Cleaning error (Ink low error) according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
• Operation
•–
Head Cleaning is not carried out. Ink Cartridge
1. Check if the ink remains in the Ink Cartridge. 1. Replace the Ink Cartridge with a new one.
2. Check if the Ink Cartridge can be used by installing it to
other printer.
2. Replace the Ink Cartridge with a new one.
Table 3-12. Check point for DSC Direct error according to each phenomenon (NX510/SX410 series only)
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
• Operation
•–
The Digital Camera (as a USB device)
cannot be recognized and an error is
indicated.
USB Cable 1. Check if the USB Cable is damaged. 1. Replace the USB Cable with a new one.
Digital Camera
2. Confirm whether the digital camera is compatible with
the printer.
2. Replace the digital camera with a compatible
one.
Table 3-13. Check point for Memory Card error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
• Operation
•–
The Memory Card cannot be recognized
and an error is indicated.
Memory Card
1. Check if the Memory Card is compatible with the
printer.
1. Replace the Memory Card with a compatible
one.
2. Check if the Memory Card is damaged. 2. Replace the Memory Card with a new one.
3. Check if a memory card that the adaptor is needed is
inserted into the slot without using the adaptor.
3. Turn off the printer, then remove the card
using tweezers or a similar tool.
Main Board Unit
1. Check if the Memory Card slot pins on the Main Board
is bent or broken.
1. Replace the Main Board Unit with a new one.
Table 3-10. Check point for Paper out error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy

Epson Stylus NX510 Specifications

General

Brand	Epson
Model	Stylus NX510
Category	Printer
Language	English