Figure 4-1. Disassembling Flowchart
You need to remove the parts/units shown in
dashed line box if they exist on the way to the
target part/unit.
Colored blocks are the sections where
disassembling/reassembling procedures differ
between models.
Unless otherwise specified, this chapter
describes the disassembling/reassembling
procedures based on NX510 series.
“ 4.4.2 Panel Unit/LCD Unit ” (p108)
“ 4.3.1 Paper Support Assy ” (p98)
“ 4.6.2 Scanner Carriage Unit ” (p142)
“ 4.6.1 Upper/Front Scanner Housing ” (p141)
“ 4.5.15 Upper Paper Guide ” (p132)
“ 4.3.4 Scanner Unit/Hinge ” (p100)
“ 4.4.2 Panel Unit/LCD Unit ” (p108)
“ 4.4.1 Main Board Unit ” (p105)
“ 4.5.6 Front Frame/Right Frame ” (p120)
“ 4.5.3 Hopper ” (p116)
“ 4.5.13 Main Frame Assy ” (p128)
“ 4.5.9 PF Encoder Sensor ” (p123)
“ 4.5.19 PF Roller ” (p138)
“ 4.3.5 Upper Housing/Card Slot Cover ” (p103)
“ 4.5.2 CR Scale ” (p115)
“ 4.3.2 Stacker Assy ” (p98)
“ 4.3.3 Document Cover/ASF Cover ” (p99)
“ 4.5.16 ASF Unit ” (p132)
“ 4.5.18 Front Paper Guide ” (p137)
“ 4.5.4 Removing the Printer Mechanism
(Lower Housing) ” (p117)
“ 4.5.9 PF Encoder Sensor ” (p123)
“ 4.5.2 CR Scale ” (p115)
“ 4.5.3 Hopper ” (p116)
“ 4.5.17 Ink System Unit ” (p134)
“ 4.5.12 CR Motor ” (p127)
“ 4.5.5 Left Frame ” (p119)
“ 4.5.7 Star Wheel Holder Assy ” (p122)
“ 4.5.7 Star Wheel Holder Assy ” (p122)
“ 4.5.8 EJ Roller ” (p122)
“ 4.5.11 PF Motor ” (p125)
“ 4.5.7 Star Wheel Holder Assy ” (p122)
“ 4.5.10 PF Scale ” (p124)“ 4.5.8 EJ Roller ” (p122)
“ 4.5.14 CR Unit ” (p131)
“ 4.5.10 PF Scale ” (p124)
“ 4.6.3 Scanner Motor Unit ” (p144)
“ 4.5.10 PF Scale ” (p124)
“ 4.4.3 Power Supply Unit ” (p111)
“ 4.5.1 Printhead ” (p113)
“ 4.5.20 Waste Ink Pads ” (p139)
To Next Page
Loading...
Need help?
General