Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510 Revision A
TROUBLESHOOTING Network Troubleshooting (NX510 series only) 90
Confidential
 Troubles during printing and scanning from PC
Table 3-27. Troubles during printing and scanning from PC
Symptom Check Point Remedy
Print cannot be made
Scan cannot be made
1. In Wireless LAN’s case, check if
the network connection between
the PC and Access Point is made.
Correctly connect the
computer and the Access
Point.
2. In Wired LAN’s case, check if
the computer and the printer are
properly connected to a LAN
port such as a hub or router.
Correctly connect the
computer and the printer to a
LAN port such as a hub or
router using a LAN cable.
3. Check the status of network
settings/connection by printing
the network status sheet.
Correctly set the network
connection again if the
network connection is not
made.
4. Check if the link lamp on the
Access Point or hub connected to
the printer is lighting or flashing.
• Try using another port.
• Replace the LAN cable.
• Configure Wireless LAN
setting correctly.
5. Check if the network settings are
correctly configured?
Correctly configure the
network settings.
6. Check if the network setting
screen is displayed on the
Control Panel.
Close the screen.
EPSON Scan cannot
be started
1. For EPSON Scan settings, check
if IP address is set directly.
If IP address is set using the
DHCP function, specify IP
address by searching address.

Epson Stylus NX510 Specifications

General

Brand	Epson
Model	Stylus NX510
Category	Printer
Language	English