Epson WF-C5790 - Page 509

EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a Revision A
Disassembly/assembly Disassembly/Reassembly Procedures 509
Confidential
Ink Supply Tube
After ink charging, follow the instructions on the Ink leak check (p.563) to remove the
LEAK TESTER SHEET FRONT/REAR, then perform Leak Check Judgement.
Head Screw Assy
In the following steps, ink may spill from the Ink Supply Tube. Prepare waste cloths
or similar in advance.
1. Remove the two screws (S8: ), and remove the Ink Supply Tube from the Printhaed.
Make sure the plate was attached.
A20
No. Screw Type
S8
C.B.EP-TITE SCREW,2.6X17(B=14),F/ZN-3C
Ink Supply Tube
Plate