This chapter describes the maintenance procedures you can carry out on the tracer centerer-blocker without
the help of a technician.
• Carry out autotests (F p.104)
• Checking and calibrating the tracer (F p.105)
• Viewing the statistics and technical history (jobs and actions carried out) (F p.113)
• Maintain and clean the tracer (F p.115)
1. CARRYING OUT THE AUTOTESTS
This menu is used for auto-diagnosis of the tracer-centerer-blocker functions and to test the operation of the
blocking arm and the tracing table.
Blocking arm
Select > from the work screen.
1. Blocking arm movements
2. Optical tests
Select the autotest to be carried out.
Press to start the test cycle.
A warning message is displayed.
Remove any objects from within the centering chamber.
Press on to confirm.
You can press to stop the auto-test cycle on the arm at any time.
The result is displayed on the right of the icon of the autotest carried out:
• The equipment is operational.
• A malfunction has been detected, a description is shown in the message box at the
bottom of the screen.
To Next Page
Loading...
Need help?
General
