This equipment complies with the limits imposed by Part 15 of the FCC rule. Its use meets the following conditions: (1) this device must not
cause interference and (2) must accept interference from external sources, notably that liable to cause malfunctions.
In accordance with the requirements of FCC rules, any modification made to this equipment which is not expressly approved by ESSILOR
INTERNATIONAL would nullify the user's right to use this device.
This equipment has been tested and is deemed compliant with the limits imposed for Class-B digital devices according to Part 15 of the FCC
rule. Those limits are set so as to ensure reasonable protection against interference in a residential environment. This equipment generates,
uses and may emit radiofrequency energy liable to interfere with radio communications if the device is not installed and used in strict
compliance with manufacturer instructions. However, nothing guarantees the absence of interference under particular conditions. If this
equipment is the source of interference with radio or television reception (this can be confirmed by switching off the device then turning it
back on), the user may be able to eliminate this interference through one or more of the following measures:
• Swivel of move the affected receiver or its receiving antenna;
• Move the device away from the affected receiver;
• Connect the device to a different circuit to that powering the affected receiver;
• Request help from the retailer or a qualified radio / television technician.
4. COPYRIGHT
Copyright © 2013 Essilor - Translated from the original manual
All rights reserved. Any reproduction of the content of this document, whether in part or as a whole, for the purpose of its publication or
dissemination by any means and in any format whatsoever, even free of charge, is strictly prohibited without prior written consent from
Essilor.
5. MATERIALS AND PRODUCTS
Do not place this machine in a dusty environment, in a room where the temperature is too high or too low or in a damp place.
This product notably has a joint on/off button and a hazard label that it contains Bis (2-éthylhexyle) Phthalate (DEHP).
6. SAFETY INSTRUCTIONS:
All mechanical or electronic adjustments and electrical maintenance must be carried out by a customer service technician approved by
Essilor.
The use of an accessory or a cable other than those recommended in this manual can be dangerous for users.
Check the power cable regularly; if damaged, have it replaced by an approved repairer.
Do not use your system in any way other than described in this document. Otherwise, the protection provided by the device could be
compromised.
Never try to modify or dismantle this product yourself. In addition to the fact that you are likely to damage the instrument, you can also
injure yourself.
Your tracer must be carefully maintained, in accordance with the instructions detailed in this document.
Your system is an electrical appliance compliant with the applicable safety standards. In the event of malfunction, repairs must be carried
out by qualified personnel approved by Essilor. Otherwise, user safety is likely to be compromised.
In the event of a long period of non-use and before maintenance and/or replacement of certain accessories, you must unplug your system
from the mains.
The equipment must be plugged into an earthed power supply. The earthing must comply with public standards and be checked by a
technician. Avoid using extension cables or adaptors which could create a poor contact.
Never pull on the cables to unplug them from the power socket.
To Next Page
Loading...
Need help?
General
