3. USING THE TRACER-CENTERER-BLOCKER
In this section, you will find all the information concerning the following:
• turning the tracer-centerer-blocker on and off, (F p.12)
• use of the touch screen and keyboards (F p.12),
• description of the work screen (F p.14).
a. Turn on and turn off the tracer-centerer-blocker
Switching on
Press the ON/OFF button located at the top right on top of the screen.
The tracer-centerer-blocker is initialized.
A beep indicates that initialization was successful.
The tracer-centerer-blocker is ready to be used when the initial screen is displayed.
Switching off
Press:
• briefly on the ON/OFF button, located at the top right at the top of the screen or
• on > , from the work screen.
Do not press on the ON/OFF button for several seconds. This would result in shut-down of the
machine and an error message would be displayed at the next switch-on.
A confirmation message is displayed.
Select to confirm.
The tracer-centerer-blocker is switched off.
Extended period of non-use
During a prolonged period of non-use (several days), it is preferable to turn off the tracer-centerer-
blocker by unplugging the mains power supply.
b. Using the touch screen and keypads
Using the touch screen
Use the stylus on the touch screen.
You can also touch the screen with your finger.
To Next Page
Loading...
Need help?
General
