Work in tracing - preparing edging - centering mode
At the end of tracing preparation, the tracer-centerer-blocker automatically displays the edging
preparation screen then the centering screen and proposes the posiblock adapted to the prepared edging.
1. Tracing or recovering a job from the database
2. Edging preparation
3. Changing the shape and drilling position if necessary
4. Centering
5. Lens blocking
To activate this working mode, select the following parameters in the configuration screen (F p.97):
Work in tracing - tracing - centering - preparing edging mode
At the end of a tracing, the tracer-centerer-blocker displays the tracing screen.
• You can perform several tracings in succession.
• The tracings are saved under the job number that you have assigned to them.
• Shape modification, centering, blocking and edging preparation are processed later.
• All jobs must be saved.
• After a job call the centering screen appears automatically, followed by the edging preparation screen.
• You can access the centering screen at any moment to centre the lens that corresponds to the active
shape:
> select then .
To activate this working mode, select the following parameters in the configuration screen: (F p.97)
Work in tracing - tracing - preparing edging - centering mode
At the end of a tracing, the tracer-centerer-blocker displays the tracing screen.
• You can perform several tracings in succession.
• The tracings are saved under the job number that you have assigned to them.
• Shape modification, edging preparation, centering and blocking are processed later.
• All jobs must be saved.
To Next Page
Loading...
Need help?
General
