Essilor Neksia User Manual

2. Cycle type
◦ Standard cycle
For all types of materials.
◦ EAS
TM
For all types of materials. This cycle offers a more sophisticated edging mode than the standard
cycle, specifically for thin or small lenses, and hydrophobic lenses.
◦ Type of cycle to be defined on the edger.
3. Type of finish
◦ Bevel
◦ Groove
◦ Flat-edge
◦ Finish to be defined on the edger
4. Accessing the drilling preparation screen
5. Edging mode
◦
◦
The edging mode is defined automatically according to the settings previously selected.
6. Polishing
◦ Polished lens
◦ Non-polished lens
◦ Polishing to be defined on the edger
7. Front surface chamfering
◦ Thin chamfer front surface
◦ Thick chamfer front surface
◦ No chamfering
◦ Chamfer to be defined on the edger
8. Rear surface chamfering
◦ Thin chamfer front surface
◦ Thick chamfer front surface
◦ No chamfering
USER MANUAL> VI. PREPARING LENS EDGING
89
Neksia > v1-02-14

Essilor Neksia Specifications

General

Brand	Essilor
Model	Neksia
Category	Edger
Language	English