Overview 7
System Limitations
Group
• Maximum Racks: 16
• Maximum Dimmers: 1536
• DMX Output only from last rack
• DMX output is considered 512 virtual dimmers for maximum dimmer count
• Maximum Presets: 128
• Maximum Rooms: 4
• Maximum Active Presets: 4
• Panic: 1 per group
• UL 924 compliance requires wires to be landed on every emergency rack with normally open,
maintain closure type
Rack
• Voltage Ranges:
- UL 120V 90-135V (Dimmer output turns off if voltage is less than 90V or greater than 140V)
- CE 180-280V (dimmer outputs turn off if voltage is less than 180V or greater than 280V)
• Frequency Range: 47-63 Hz
• Maximum number of sACN sources: 6 (per universe)
• Maximum Number of valid patch universes: 2
For sACN: 4 universes per rack (if last rack, this includes B-out patching)
• Maximum number of ACN subscribers: 12 (for configuration and reporting)
Dimmer
• Maximum number of rooms assigned to: 1
• Dimmer numbers must be unique within a group. Configurations with duplicate dimmer
numbers will be rejected.
General behavior
• Dimmer modes work only as property “defaults” such that you do not have to know how to set
up each dimmer type beyond general function requirements such as “run like a relay” = switch
and “run like a forward phase dimmer” = normal.
• Data loss activates per port type. EDMX and sACN responds to data loss on a per dimmer basis
though DMX responds per port.
SmartLink
• Maximum number of Sensor+ SmartLink power supplies in a SmartLink system: 1 (must be
installed in Rack 1 of group)
• Maximum number of SmartLink control stations on a SmartLink power supply in a group: 4
• Maximum amount of SmartLink enabled products connect to a Sensor+ SmartLink power board:
4 (excluding Sensor Racks and SmartLink stations)
• Maximum number of groups activating presets from a single SmartLink network: 4
To Next Page
Loading...
