Introduction 1
Introduction
Congratulations on your purchase of an ETC Sensor+ system. Sensor+ continues ETC's tradition of
providing the highest quality products for the entertainment lighting market.
Using this Manual
This manual contains information on using and configuring features of the Sensor+ CEM+ in any
Sensor+ rack or pack available up through the Power User login user level.
The following symbols are used in this manual to alert you to danger or important information.
Email comments about this manual to: TechComm@etcconnect.com.
What’s New in v3.1
Here’s a list of changes and new features in v3.1:
• Load High Error increased from 135 VAC to 140 VAC
• AF improvements
- Added “no load alarm”
- No load alarm can be disabled per rack
- Actual loads report without recording loads
- Loads now displayed in Amps
- Load accuracy consistent across all circuits
- Minimum load 300W resistive
• Basic Portable Mode improvements
- Activated DMX B Input
- Added menu for option to change between normal/switched operation per dimmer
- Added menu option to choose single or three phase operation.
Note:
Notes are helpful hints and information that is supplemental to the main text.
CAUTION:
A Caution statement indicates situations where there may be undefined or
unwanted consequences of an action, potential for data loss or an equipment
problem.
WARNING:
A Warning statement indicates situations where damage may occur, people
may be harmed, or there are serious or dangerous consequences of an action.
WARNING:
RISK OF ELECTRIC SHOCK! This warning statement indicates situations where
there is a risk of electric shock.
Note:
Dimmer output shuts off at 140V. Suggested incoming voltage is 135V or less in
order to allow for line voltage fluctuation.
To Next Page
Loading...
