ETC sensor+ CEM+ - About

78 Sensor+ CEM+ User/Config Manual
About
Press Enter to view[
Rack Errors]
Access Granted
Level: User
Access Granted
Level: Power
Anything else
Password
Valid
Rack: xx/xx OK
About
Rack: xx/xx OK Rack: xx/xx OK
A: 101 B:--- E: Off S: Off
if Error
No
Enter to clear +/-
[Ambient Overtemp]
Yes
About
[Group]
About
[Rack Power]
About Group >xx<
Players Theatre
About Rack Power
60.0 Hz 3Ø Wye
About Software
Version >3.1.0.9.0.xx<
About
[Network]
About Gateway
>www.xxx.yyy.zzz.<
About Subnet Mask
>www.xxx.yyy.zzz.<
About IP Address
>www.xxx.yyy.zzz.<
Voltage Headroom
VH a:20 b:16 c:19
About
[Rack Data Ports]
About Data Ports
DMX A:OK 8 Bit
About Data Ports
DMX B:OK 16 Bit
About
[Rack General]
About nnnnnnnnnnnn
Amb> 75<F Air >OK<
About nnnnnnnnnnnn
Type: >SR48<
About Dimmer
Select dimmer [xxx]
About Dimmer >xxx<
>yy%< >srcxxxx<
About Dimmer >xxxb<
>yy%< >srcxxxxx<
About Dimmer >xxx<
Type > D20 <
Rack: xx/xx OK
[Login]
Logged in as User
PIN:[0] 0 0 0
Select Rack 1/ 1
>nnnnnnnnnnnnn<
Select Rack 1/ 1
[ SR48#001 ]
Select Rack 1/ 1
[ SR48#001 ]
Select Rack 1/ 1
[ SR48#001 ]
Cleared Error
>Ambient Overtemp<
About Dimmer xxxxx
DMX A:xxx B:xxx
About
[Identify Rack]
Select Rack 1/ 1
[ SR48#001 ]
About Rack Power
V a:123 b:125 c:126
About nnnnnnnnnnnn
Clean Due: >128< hrs
About Dimmer xxxxx
Net E:xxxxx S:y/xxx
About Dimmer xxxxx
Rack rr Position pp
About Dimmer xxxxx
Rack rr Position pp
About
[Dimmer]
if Panic Active
No
Yes
Panic Active!
Deactivate Panic
Panic DeactivatedEmergency!
Panic Activated!
About
[Rack General]
About Dimmer >xxx<
Mode > Normal <
About Dimmer >xxx<
Rec>xxxx< Act>xxxx<
About Dimmer xxxxxb
About Data Ports
EDMX:OK 16 Bit
About Data Ports
sACN: Off 8 Bit
If B side
Yes
If B side
Yes
If B side
Yes
No B side
No B side
DMX A:xxx B:xxx