88 Sensor+ CEM+ User/Config Manual
Configuration Changes
In addition to status, remote computers and lighting devices can also change settings that would
typically be performed during pre-show technical sessions.
These potential configuration changes include:
• group (system) name
•rack name
• dimmer name
•mode
•curve
• threshold
• minimum scale voltage
• maximum scale voltage
• set preheat enable
• set preheat timing
• AF enable
• clear errors
When AF is enabled the following are also available:
• record loads by range
• record loads by control
• delete recorded loads by range
• delete recorded loads by control
• check loads by range
• check loads by control
ACN Control
Control of the dimming system during a show is provided by DMX, EDMX, or sACN; however, several
control override mechanisms exist in a Sensor+ rack and they are also available remotely for access over
ACN. These overrides are:
• set dimmer levels
•preset
-activate
- deactivate
- record (snapshot)
- delete
• Panic
-activate
- deactivate
- record (panic)
To Next Page
