ETC sensor+ CEM+ - Rack Menu

80 Sensor+ CEM+ User/Config Manual
Rack Menu
Please Wait
Updating Patch
Hold Last Look
Rack: xx/xx OK
[Rack]
Setup Rack
[Patch]
Patch Range
From Dimmer [xxxxx]
Wait & Fade
Fade Time [00]:[02]
DMX Loss Behavior
[Wait & Fade]
Setup Rack
[DMX Loss Behavior]
Select DMX Port
[DMX A]
If
Wait & Fade
Wait Time [03]:[00]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Play Preset
Wait & Fade
Setup Rack
[Set First Dimmer]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Set First Dimmer
Dimmer [ ]
Patch Range
Thru Dimmer [yy
yyy]
Enter or 3 second timer
Setup Rack
[DataPort & Priority]
Port [DMXA]
[On] Priority [10]
Set Presets & Rooms
In Group Menu
Patch Dimmer Ranges
To [DMXA]
Press back or home key to exit
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Patch Sides
Both - Sequentialy
Dim xxxxx-yyyyy A
DMXA xxx - yyy
Yes
Dimmersxxxxx-yyyyy
To DMXA [xxx]
Hotel Number all
Racks in Group [Y]?
Rack> 1< [DMXA]
Start [xxx]
Patch Dimmers
[by Start Address]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Port A Dimmers
From [xxxxx] to [yyyyy]
Patch Dimmers
[Rack Split]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Patch DMXA
From [xxx] to >yyy<
Rack> 1< Continues
On DMXB Ch1? [yes]
If DMX
crosses the
boundry
Port B Dimmers
From [xxxxx] to [yyyyy]
Patch DMXB
From [rrr] to >sss<
If any doubled
dimmers
No
Patch Dimmers
[By Ranges]