ETC sensor+ CEM+ - Upload a Configuration

CEM+ Procedures 51
Upload a Configuration
Browse to the File Upload web page and click Browse to
select a file to upload to the local CEM+. Once the file is
selected, click Install and the file will begin to transfer to
the CEM+. This is the same place and manner to send
either a configuration file or a software file. The CEM+
looks at the file being sent to automatically handle the file
type or part of the configuration file. In the same way, it doesn’t matter if the file ends with .rak or .xml
when it is sent.
FTP Server
An FTP server can be configured to be on the ETCNet2 network and act as a file storage location for the
configuration files of the group.
An FTP server is not provided as standard with a CEM+.
CEM+ modules can access any stock FTP server that is configured with the following minimum
settings:
• IP address of the FTP server needs to match the one specified in the network table in
the configuration.
• The CEM+ uses an authenticated login so the FTP server must have a user created
and configured for the CEM+. (The user name and password are usually case-
sensitive.)
• User name: etc
• Password: sensor
• The FTP server must have a specified default file storage location. The CEM+ does not
specify any path to write the file to on the server. They will only go in the default root
directory.
WARNING:
By default, you cannot currently use an FTP server with more than one (1)
rack group at the same time. All CEM+ modules will send their configurations
to the FTP server with the same file names and the same directory (root) and
will overwrite other configuration files present.
Contact ETC Technical Services if this is a requirement of your system.