ETC sensor+ CEM+ - Login

12 Sensor+ CEM+ User/Config Manual
Dimmer
About Dimmer provides information about a selected dimmer, including recorded and actual loads, the
dimmer type, curve and maximum voltage. You can also view the current output level, the source of
that level, and the dimmer’s location.
Rack General
The Rack General menu provides the current ambient temperature and air flow status of the selected
rack. It also displays the rack type, the air filter cleaning reminder setting, and the number of hours
until the air filter cleaning reminder is due.
Network
About Network provides the network settings for the currently selected rack. You can view the settings
for any rack in the Group.
Rack Data Ports
About Rack Data provides status information for the DMX, EDMX and sACN inputs for any rack in the
Group.
Rack Power
About Rack Power provides status information for the line feed power and the voltage headroom
settings for any rack in the Group.
Identify Rack
Identify Rack flashes the LCD and buttons on the face panel of the selected rack.
Group
About Group provides the name set for the Group.
About Software
Provides the software version currently installed in the racks.
Login
The Login menu is where you enter the PIN number for the user level you want to access. User level
needs no PIN to view the menu items accessible to them. You will need to enter a four-digit PIN to gain
access to features that are restricted to higher user levels. Enter the default PIN of 3333 to gain Power
User level access. Use and to scroll the digits and use to enter the set digit.
Dimmer [User][Power]
The Dimmer menu allows you access to setting and releasing dimmer levels, and Power allows access to less commonly accessed features such as renaming of
racks and dimmers as well as higher level module setup items such as setting the scale and preheat properties, advanced feature settings, and deleting the
configuration.
Set/Release Levels
The Set Levels menu allows you to set (or release) a dimmer or a range of dimmers to a specified level
at the CEM+. Levels set here take priority over any other level inputs, such as control consoles and
architectural control systems. Once released, those dimmers are available to other control inputs.
Levels set here do not take priority over levels generated by an active Panic look.
The button on the CEM+ face panel accesses this menu directly.
Note:
Power User PIN can be modified for security purposes if required. See Set PIN [Power]
on page 20.