20 Sensor+ CEM+ User/Config Manual
Record Loads [Power]
The Record Loads menu is used to record the loads on each dimmer. This is useful in Advanced
Features systems where load reporting is desired.
Name Group [Power]
The Name Group menu allows you to set the name of the Group. Names are alphanumeric and can be
up to 20 characters long (not all 20 characters will be visible on the LCD).
Set Language [Power]
The Set Language menu allows you to set the language of the user interface.
Ambient Temp Type [Power]
The Ambient Temp Type menu allows you to set temperature reporting as either Fahrenheit or Celsius.
Set Time Zone [Power]
The Set Time Zone menu allows you to set the GMT offset for your current time zone.
DST Mode [Power]
The DST Mode menu allows you to set daylight savings to be Auto, On or Off.
Set Login Time-out [Power]
The Set Login Time-out menu allows you to set the time after which the CEM+ will automatically log
the current user out and return to the default access level as set in the Group configuration. The time-
out is based upon inactivity at the keypad.
Set PIN [Power]
The Set PIN menu allows you to set the PIN for login access below your current login access level.
Set Default Access [Power]
Set Default Access allows you to specify which user level the CEM+ boots and remains in. This can be
either User or Power.
To Next Page
Loading...
