ETC sensor+ CEM+ - Appendix H ACN Reporting; About ACN; ACN Net3 Reporting

CEM+ LCD Menu 81
Setup Rack
[Get Config]
Setup Rack
[Send Config to All]
Setup Rack
[Delete All Racks]
Setup Rack
[Network Defaults]
Updating Settings
Please Wait
Save Changes
[No]
Network Defaults
[No]
Setup Rack
[Configure Fan]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Setup Rack
[Set Temp Alarm]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Set Temp Alarm
Temp [104F]
Setup Rack
[Set Phase Balance]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Set Phase Balance
[Balanced-3Phase]
Setup Rack
[Advanced Features]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Setup Rack
[Voltage Headroom]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Voltage Headroom
Headroom [ 90]v
Setup Rack
[Set Network]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Set Gateway
[ 10].101.114.101
Network Enable
[Enabled]
Enable BootP
[Disabled]
Set IP Address
[ 10].101.114.101
Set Subnet Mask
[255].255.0.0
Setup Rack
[Add Rack]
Set Group/Rack
Racks To Add [ 1]
Set Rack Type
[SR48]
Set First Dimmer
Dimmer [ 97]
Set Temp Alarm
[104] F
Set Module Type
Module = [D20]
Set Phase Balance
[Balanced-3Phase]
Advanced Features
[Off]
Save Changes?
[NO]
Configure Fan
[No data/15 min]
Setup Rack
[Air Filter Timer]
Set clean time
Hours of use [xxx]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]
Get From Rack [xx]
[Nnnnnnnnnnnnnnnn]
Reboot Required
[Cancel]
IP,Subnet
Or Gateway
Changed?
Cancel
Enabled Yes
No
Advanced Features
[Off]
No Load Errors
[Disabled]
To - On Boot
Setup Rack
[Set Rack Name]
Name Rack
[Nnnnnnnnnnnnnnnn]
Set Group/Rack
Rack Number [__]
Setup This Rack
[Set Group/Rack]
Set Group/Rack
Group Number [__]
Select Rack 1/ 1
[Nnnnnnnnnnnnnnnn]