ETC sensor+ CEM+ - Page 92

86 Sensor+ CEM+ User/Config Manual
Rooms & Presets + Room 1 + Room 2 + Room 3 + Room 4 + Assign Dimmers
Room # • View presets in room • Record presets • Activate/deactivate presets • Clear presets • Set dimmer levels • Set Power Up behavior'
Configuration + Panic + Patch + Network + File transfer + File upload + Load Management
Assign Dimmers • Assign individual dimmers to a room • Assign ranges of dimmers to a room • Enable/Disable Station Proxy (Station Master) • Enable/Disable Button Program (Recording of presets from the stations)
Room Properties • Set room name • Set maximum number of active presets in a room • View dimmers assigned to a room
Edit • Create new presets • Set preset properties • Set dimmer levels
Panic • Set switch mode • Set switch type • Set master level • Set load shedding (force others off) • Record / clear panic Port Settings • Set starting address per port per rack • Enable / disable ports • Set port priority • Set data loss behavior • Enable / disable DMX Output for Port B of last rack
Patch • Individual dimmer patching per port • Range patching per port • Range unpatching per port
Network • Set Group and Rack number • Set CEM+ face panel time-out • Set default login access level • Restore network default IP addresses File Transfer • Get a configuration from another CEM+ • Send local configuration to all other CEM+s in group • View configuration (as raw xml) • Download configuration to disk (right-click) Load Management • View individual dimmer recorded loads and actual loads • Load check • Record loads • Clear loads File Upload • Upload CEM+ software to local CEM+ • Upload configuration file to local CEM+