DEPOLOX
®
Pool Defining the Application
WT.050.570.000.DE.IM.0714 101
2.5
2.5 Defining the Application
The configuration of the system is determined by the required measu-
rement and control parameters, the installed system components and
the selection of the suitable application.
The connections are determined by the selection of the application 1,
2, 3 or 4. Works settings are always set for the respective application.
These can, however, be customised as required.
CAUTION!
The defined application 1, 2, 3 or 4 must be entered the first time the
device is switched on, refer to the section "Commissioning, Switching
the Device on".
It is then not possible to change this for the defined configuration, as
otherwise incorrect controller outputs could be activated.
The following pages show the four applications 1, 2, 3 and 4. The illus-
trations show the options for wiring of the inputs and outputs.
To Next Page
Loading...
