Evoqua DEPOLOX - Filling Cell Sand; Sensor Arrangement

134 WT.050.570.000.DE.IM.0714
Installation / Commissioning DEPOLOX
®
Pool
2.7
2.7.1 Filling Cell Sand
CAUTION!
Before opening the cover on the pressurised version always first re-
lease the pressure in the cell body with the drain screw.
1. Remove the cover from the cell body:
 On the non-pressurised version lift the cover.
 On the pressurised version unscrew the cover.
2. Fill half a screw cap of "cell sand" (W3T171317) into the cell body,
also refer to the section "Maintenance".
3. Refit the cover onto the cell body.
 On the non-pressurised version align the catch on the cover
and snap the cover into place.
 On the pressurised version screw the cover into place. The
correct position is reached at the end of the thread.
Sensor
arrangement