136 WT.050.570.000.DE.IM.0714
Installation / Commissioning DEPOLOX
®
Pool
2.7
Fig. 40
1 Plug-in card Cl
2
2 Plug-in card pH
3 Plug-in card Redox
4 Plug-in card Cl-N
5 Plug-in card conductivity
6 Plug-in card mA-out
7 Relay card
8 Terminal strip
The plug-in cards for the sensor measuring modules specified in the or-
der are already fitted. Except for the multi-sensor, all sensor cables are
already connected to the plug-in cards.
NOTE
Should you wish to retrofit additional sensor measuring modules, infor-
mation is provided in the packaging of the additionally ordered sensor
measuring modules.
Connecting the sensor
cables
1. Place the sensor cables with the attached bushes into the cable
ducts of the housing.
2. Depending on the sensor design, either plug or plug and screw the
cable in place.
3. Mount the multi-sensor with the temperature measuring cable to
the flow control valve. Place the temperature measuring cable into
a duct and connect in the electronic module - refer to terminal dia-
grams. Note that the shield of the four-core temperature measuring
cable must also be connected.
4. Fit the supplied bushes to ducts which are not in use in order to
seal the housing.
To Next Page
Loading...
