Evoqua DEPOLOX - Installation Version Without Mounting Rail

DEPOLOX
®
Pool Installation
WT.050.570.000.DE.IM.0714 99
2.4
The electronic module and the flow block assembly can be mounted in
different places, the modules can be hooked onto suitable tallow-drop
screws by the top holding fixtures instead of onto the mounting rail.
Subsequent installation procedures are described above.
NOTE
If the electronic module and the flow block assembly are mounted at se-
parate locations, the sensor cable extensions with a maximum length
of 50 m must be used. An impedance converter for the Redox and pH
sensors is also required (part no. W3T165563).
B
B
S c h n i t t B - B
2 1 0 3 1 6
3 5 02 6 3
4 5
6 5
4 5
8 5
3 5 1 4 0 1 9 4
3 0 , 5
3 2
1 7 0
ø 5 , 5
7 0
2 0 7
2 5 2
2 4 7
5 1 , 52 0 21 7 0 , 5
3 , 5
Fig. 25
Installation version wit-
hout
mounting rail